Network Topologies

Added on April 5, 2026

Star Topology

The main premise of a star topology is that devices are individually connected via a central networking device such as a switch or hub. This topology is the most commonly found today because of its reliability and scalability - despite the cost. Any information sent to a device in this topology is sent via the central device to which it connects.

Bus Topology

This type of connection relies upon a single connection which is known as a backbone cable. This type of topology is similar to the leaf off of a tree in the sense that devices (leaves) stem from where the branches are on this cable.

Because all data destined for each device travels along the same cable, it is very quickly prone to becoming slow and bottlenecked if devices within the topology are simultaneously requesting data.

Bus topologies are one of the easier and more cost-efficient topologies to set up because of their expenses, such as cabling or dedicated networking equipment used to connect these devices.

Another disadvantage of the bus topology is that there is little redundancy in place in case of failures. This disadvantage is because there is a single point of failure along the backbone cable. If this cable were to break, devices can no longer receive or transmit data along the bus.

Ring Topology

The ring topology (also known as token topology) boasts some similarities. Devices such as computers are connected directly to each other to form a loop, meaning that there is little cabling required and less dependence on dedicated hardware such as within a star topology.

A ring topology works by sending data across the loop until it reaches the destined device, using other devices along the loop to forward the data. A device will only send received data from another device in this topology if it does not have any to send itself. If the device happens to have data to send, it will send its own data first before sending data from another device.

Because there is only one direction for data to travel across this topology, it is fairly easy to troubleshoot any faults that arise. However, this is a double-edged sword because it isn't an efficient way of data travelling across a network, as it may have to visit many multiple devices first before reaching the intended device.

Ring topologies are less prone to bottlenecks, such as within a bus topology, as large amounts of traffic are not travelling across the network at any one time. The design of this topology does, however, mean that a fault such as cut cable, or broken device will result in the entire networking breaking.